0
What else can I help you with?
Where is the generic electricronic module 1998 Windstar?
In the 1998 Ford Windstar, the Generic Electronic Module (GEM) is typically located under the dashboard on the driver's side, near the steering column. It is usually mounted to the vehicle's body or firewall. Accessing it may require removing some trim panels for better visibility and reach.
How do you change a 4 wheel drive module in a 1998 explorer?
As far as I know, there wasn't a separate module for the 4 wheel drive from 1995 to 2000, the 4x4 system was controlled by the GEM ( Generic Electronic Module) This module incorporates the functions of several different modules into one and offers diagnostic codes to locate failures ( see a dealer's service department for diagnosis ) The GEM is located in the centre stack of the dash, remove radio to gain access.
Where is the wiper motor pulse board module on a 1998 Ford Explorer 4.0 L?
The Ford Explorer was produced from the years 1990 to present. The wiper motor pulse board module in a 1998 Ford Explorer 4.0 L is located on the firewall, behind the engine in the middle.
What does a RAP module do in a 98 Ford Explorer?
In a 1998 Ford Explorer : The RAP module ( Remote Anti-theft Personality module ) is used with your anti-theft system and your keyless remotes ( each vehicle with keyless entry has it's own factory code )
Where is the computer module located on a 1998 for explorer?
On a 1998 Ford Explorer : You can seeone end of the Powertrain Control Module ( PCM ) in the engine compartment . It passes through the firewall , from the engine compartment end you can see where the wiring harness is bolted to it , and most of the PCM is " hidden " behind the glove compartment
Where is the Generic Electronic Module in the lift gate washer located in the 1998 Ford Explorer Sport?
Ford has been know to mount the GEM under the dash near or underneath the instrument panel fuse box. That would be a logical place to look. Some times the fuse panel is mounted in the kick panel under the dash just inside the door near the brake pedal. Happy hunting!
Location of RAP module on a 1998 explorer?
I believe that is in the jack storage area in the cargo area , on the drivers side by the liftgate
Electronic control module replacement on 1998 ford expedition?
my directional lights and speedometer do not work could this be control mudule?
Where is the air bag module on 1998 ford explorer?
air bag control module under the kick panrl to the right foot on the pasenger side ,between the fender and the plastic interior
Computer module location in a 1998 ford explorer xlt?
at the left side of rear compartment where the jack is. on the sticker of the the yellow box.
Where is the air suspension electronic control module on a 1998 Lincoln mark 8?
Usually in the trunk on the right hand side behind the carpet.
How do you replace the GEM module on a 1998 Ford Windstar?
To replace the GEM (Generic Electronic Module) on a 1998 Ford Windstar, start by disconnecting the negative battery cable to ensure safety. Remove the trim panel to access the GEM, which is typically located above the driver's side kick panel. Disconnect the wiring harness from the GEM and unbolt it from its mounting location. Install the new GEM by reversing these steps, ensuring all connections are secure before reconnecting the battery.
