0
Where is the heater resistor and how do you replace the blower motor on a 93 Chevy truck?
To get access to the heater resistor you will have to take the passenger side glovebox liner out by unscrewing the screws holding it in place.You should see where 2 or 3 wiring connectors are secured.Look above and behind these connectors and you will wiring connector that appears to plug directly into the air circulation housing,but actually that is the resistor screwed into the housing.Disconnect the wiring connector and the2 screws holding it into place and it will pull right out.There is not a lot of room to work back there so you may have a little trouble getting to that right side screw.Good luck
how do you change a blower motor on a 99 Chevy k2500
What else can I help you with?
How do you replace a resistor heater blower in a 1994 Chevy van?
To replace the resistor heater blower in a 1994 Chevy van, first disconnect the vehicle battery to ensure safety. Locate the blower motor resistor, which is typically found near the blower motor under the dashboard on the passenger side. Remove the screws or bolts holding it in place, disconnect the wiring harness, and then replace it with the new resistor. Reassemble everything, reconnect the battery, and test the blower to ensure it operates properly.
Where is the heater blower motor resistor on a 1999 Chevy blazer?
On a 1999 Chevy Blazer, the heater blower motor resistor is typically located under the dashboard on the passenger side, near the blower motor itself. It is often mounted to the HVAC housing and can be accessed by removing the lower dash panel. Ensure to disconnect the battery before attempting to replace it to avoid any electrical issues.
Where is the resistor pack on a 1999 Chevy Metro?
If you are referring to the blower motor resistor, it is located behind the glove box and in the heater case.
1995 Chevy blazer heater blower will not work replaced it with a new one and it still will not work?
probably the blower motor resistor
Where is the heater resistor located on a 2000 Chevy Venture van and were is the best place to buy a fanac control switch?
resistor usually located by blower motor.blower only works on low or high,then replace resistor .do not replace hvac unit in dash waste of time and money
Removal of blower motor resistor on 2003 Chevy silverado?
Replace shoes brake 2003 Chevy
How do you replace a blower motor resistor in a full size 1992 Chevy Blazer?
take it to a shop and have them do it If it's the same as a pickup, take out the glove box and the resistor should be on top of the heater box. Not much too it.
Why does your heater fan run on high only in your 2007 Chevy Cobalt?
Blower motor resistor defective
Where is the heater blower resistor located on a 1993 Chevy G20 van?
to the left of the blower motor. It's on the left side of the engine compartment
How do you replace a blower motor resistor on 02 Chevy Prizm?
To replace the blower motor resistor on a 2002 Chevy Prizm, first disconnect the negative battery terminal to ensure safety. Remove the lower dashboard panel to access the resistor, which is typically located near the blower motor. Disconnect the wiring harness from the resistor, unscrew it from its mounting position, and replace it with the new resistor. Finally, reassemble the dashboard panel and reconnect the battery terminal.
Where is the blower motor resistor pack on a 1992 Chevy Silverado?
If yourtalking about the heater blower, I believe they are hidden behind the glove box inner liner.
2003 Chevy Silverado and you only get your heater fan motor to blow air when you turn it up to 4 or 5 What would cause this?
Defective blower motor Resistor Pack. Replace it.
