Get down in the drivers footwell and look to the left behind the clutch where the central console is. You will have to remove that vent kick-panel to get to the resistor. It uses two torx screws and is a simple 5 minute job.
Hope that helps.
A.Macdonald
To replace the heater motor in a Mk6 Ford Fiesta, start by disconnecting the battery for safety. Remove the passenger side footwell trim and any necessary panels to access the heater motor housing. Disconnect the wiring harness and unscrew the motor from its mounting. Finally, install the new motor by reversing the steps, ensuring all connections are secure before reconnecting the battery.
in the door panel and in the the rear side panels. hope this helps
5" X 7", & aparently 20 watts each
The relay on the heater/blower circuit on a Ford Escort MK6 is probably behind the glove compartment. There are two popular places that Ford puts its heater/blower relay switches. The other place would be next to the blower motor itself.
the mk6 fiesta 1.25 has 75bhp.
The MK6 Ford Fiestas take some fairly specialized wiper blades. Its best to look up the wipers by exact year rather than generation of vehicle. See sources and related links below to lookup the exact year of the Ford Fiesta.
The Ford Fiesta rear speakers measure five inches by seven inches. The front speakers measure three inches by five inches.
Depends on the engine. A variety of different petrol engines and a diesel option were fitted to the Fiesta Mk6. All have different filters.
unplug the negative terminal from the battery, and wait half an hour for the capacitors to discharge?
it is behind the lights, accessed from inside the boot, behind the side covers.
the plate when you open the drivers door, it will be two numbers, two letters or one letter and one number.
it should be located behind the glove box. You can pull the glove box out by squeezing both sides and pulling it out.