on top of the spark plug
Yes. The rear bumper cover was the same on the Infiniti G20 from 1999-2002.
Need help to disarm the alarm on 1999 infiniti g20
To change the ignition coil on an Infiniti G20, first, ensure the engine is off and cool. Disconnect the negative battery terminal, then remove the engine cover if necessary. Locate the ignition coils, detach the electrical connectors, and unscrew the bolts securing the coils in place. Replace the old coil with a new one, reattach the connectors, and reassemble any removed components before reconnecting the battery.
4
In the fuel tank
exhaust pipe
replace the leaking component
on the drivers side of the motor compartment
If a 1999 Infiniti G20 is shaking on the right front side it could be a bad wheel bearing. The rotor on that side may need to be replaced if the wheel bearing is not the problem.
The 1999 Infiniti G20 features a 2.0-liter inline-four engine, and the ignition timing marks are typically located on the crankshaft pulley and the timing cover. To set the ignition timing, you would align the timing mark on the crankshaft pulley with the corresponding mark on the timing cover while the engine is at the appropriate RPM. It's important to consult the vehicle's service manual for the exact specifications and procedures for checking and adjusting ignition timing. Always ensure the engine is warmed up and running smoothly when making adjustments.
It seems that the alarm will go off if a door that was locked is opened and the key hasn't been in the ignition or used to unlock the door for a while.
on the side of the valve cover on the drives side.