depending on the type of distributer, it would be inside the distributer. might check the pcm if you have no spark.
The 1991 Ford Probe spark ignition module can be found on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.
The ignition module for a 1991 Dodge Dynasty is typically located on the passenger side of the engine compartment, mounted on the firewall. It may also be found near the distributor or on the engine itself, depending on the specific engine configuration. To access it, you may need to remove any obstacles, such as covers or other components. Always consult the vehicle's service manual for specific details and diagrams.
It is mounted on the radiator support frame in front of the battery
in some of them it is built in with the distributer have to by the whole thing about 350.00
The Ignition Control Module is on the top left hand side of the engine under the Ignition Coils.
what is the color order of the wires to a Pontiac Sunbird ignition module
If you have disributorless ignition it will be mounted under the coil pack . If you vehicle still has a distributor it will be in the dist.
From what I can find out it seems to be located inside the distributor. You must remove the distributor cap to see it. For pictures check the link.
it is usually located on a metal bracket,close to the coil.it has a 3 wire plug attached to it.
It is located under intake manifold towards the back. It is above the starter.
Here's a link to Midcomustang.com FAQ it tells you where all the sensors are located http://www.midcomustang.com/engine_emission.htmlANSWER 2Igintion Module or Igniter Assembly is located in the distributor... I have a PDF on how to change this!
how to put in a ignition on a Honda accord 1991