answersLogoWhite

0

The input speed sensor on a 2006 Chevy Cobalt is located within the transmission assembly. Specifically, it is typically found on the side of the transmission case, near the input shaft. Accessing it may require removing some components for better visibility and space. Always refer to a repair manual for detailed guidance on locating and replacing the sensor.

User Avatar

AnswerBot

1mo ago

What else can I help you with?

Related Questions

Where is the speed sensor wire on a 2006 Nissan Altima?

can you forward me a picture of the speed sensor to a 2006 nissan altima?


Where is the knock sensor located on a 2006 Chevy Cobalt ls?

Right above the starter .


Where is the IAT sensor located in good detail on a 2006 Chevrolet Cobalt 4-cylinder?

I have a 2008 Cobalt 2.2 and it has came to my conclusion that the IAT sensor and the MAF sensor are integrated together. they are the sensor that plugs into the intake tube about 3 inches from the air cleaner box.


Where is speed sensor on 2006 Ford F-350?

speed sensor is usually on the top of the differential on a ford


Where is the transmission sensor on 2006 Ford Fusion?

looking for the location of the trans speed sensor on a 2006 ford fusion


How many forward speeds 2006 cobalt automatic?

The 2006 Chevrolet Cobalt with an automatic transmission has four forward speeds. This transmission is a four-speed automatic, providing a balance of performance and fuel efficiency for the vehicle.


How do you replace speed sensor in 2006 Toyota Camry?

tell me how to do it


What does code P0135 mean on 2006 cobalt?

The code refers to the front oxygen sensor on bank 1. That O2 sensor needs to be replaced or the wiring has come loose or is shorted out.


Where is the speed sensor on a 2006 peterbilt 387?

On top of the transmission output.


How do you check for power to the fuel pump on a 2006 cobalt?

cobalt 2006 fuel pressure pump


Where is the crank sensor located on a 2006 Chevy cobalt 2.2 engine?

The crankshaft position sensor on a 2006 Chevy Cobalt with a 2.2L engine is located on the engine block, near the crankshaft pulley. It's typically positioned on the lower rear side of the engine, close to the transmission bell housing. To access it, you may need to remove some components for better visibility.


Location of transmission speed sensor on 2006 grand prix?

show location

Trending Questions
Oil capacity of a E350 Super duty van? How do you bleed the clutch in a 96 Ranger I have followed the Haynes manual to the letter everything is new and this thing acts like I cut the line between the master cylinder and slave cylinder? What is the point gap on a 1969 Plymouth roadrunner with a 383 engine? Will a 1994 jeep wrangler hard top fit a 2005 wrangler? How can you test or erase the trouble codes manually on a 2001 Nissan Quest? What could cause an abs pump motor stall code on a 2001 dodge ram? What size belt would you use to bypass the ac compressor in a 2000 ford expedition? What causes the turn signals and hazards to work sometimes on a 1994 Jeep Grand Cherokee? What is the serpentine belt routing on a 1990 Plymouth Grand Voyager? Can bearings in a compressor be repaired? Will replacing your blower motor solve your problem it only works on high? How do you remove the spare tire under a ford explorer without the tool? What is the pressure on the turbo 400 cooling lines? How do you remove hubcaps for 1989 Oldsmobile Cutlas Sierra? What is the firing order for a 2004 ford ranger 4.0 engine? What fluid is correct for 1996 Dodge Intrepid? What is the towing capacity for a 1996 Chevrolet silverado z71 4x4 extended cab short bed with 5.7 liter engine? Why is my 2001 7.3 f250 diesel changed cam sensor but still wont start? Can 2005 stock wheels fit on your 1995 C1500 and Can the dash and instrument panel from 2004 chevy truck fit in my 1995 C1500? What size of transmission comes in a 1985 v8 305 Chevrolet Silverado?