The input speed sensor on a 2009 Chevy Malibu is typically located on the transmission. Specifically, it can be found on the side of the transmission housing, near the input shaft. To access it, you may need to lift the vehicle and remove any necessary components for better visibility and clearance. Always consult a repair manual for specific details and procedures related to your vehicle.
Where is my veh.speed sensor input location
What this trouble code means that the input power(+) to the speed sensor is low.
In a Chevrolet Malibu, the speed sensor input is typically located on the transmission. It monitors the vehicle's speed and sends this information to the engine control module (ECM) and the vehicle's speedometer. Depending on the model year, there may be variations in the exact location or type of speed sensor used. Always consult the specific service manual for detailed information on your vehicle's configuration.
it should be on front of transmission.
It is a sensor on the transmission that reads the rotational speed of the input shaft.It is a sensor on the transmission that reads the rotational speed of the input shaft.
It does not use an input speed sensor.
There isn't an input speed sensor.
Turbine input speed sensor
A 1998 Ram does not have an input speed sensor.
There is an output coming from the VSS (Vehicle Speed Sensor) and an input going into the ECM (Engine Control Module).
A 1998 Jeep with a 5.2L does not have an input speed sensor.
One of the two is located on the passenger side, near the "main" frame of the car. It was helpful for me to know what the replacement part looked like. To be slightly more specific, it is near the joint on the passenger side of the axle.