Under the front passenger seat
The jack is stored in the trunk, on the right hand side under the panel.
In a 1995 Toyota Previa, the jack is typically located in the rear compartment under the floor mat or beneath a cover. To access it, lift the floor mat or cover to reveal the spare tire and jack storage area. Make sure to check both sides, as the jack may be positioned on one side of the compartment. Always refer to the owner's manual for specific details and instructions.
To change the rear shocks on a 1991 Toyota Previa, first, safely lift the rear of the vehicle and support it with jack stands. Remove the rear wheels for better access, then locate the shock absorbers. Unscrew the bolts at the top and bottom of each shock using the appropriate socket or wrench and replace them with new shocks, ensuring they are securely fastened. Finally, reattach the wheels, lower the vehicle, and check the installation for proper alignment and function.
The fuel filter is located under the vehicle in the area just below the sliding door. You do not have to jack up the vehicle to change this. Be prepared to spill a LOT of gas when removing the filter. Work fast. Don't do it indoors.
4 screws to take off the passenger seat. 4 screws to remove the frame to where the jack and tools are stored. Pull the carpet up. Around 10 screws for the cover... Remove that, it's the engine. 3x 10mm screws to cover the plugs, take that cover out, there ya go.
In a 2003 Toyota Tacoma Extra Cab, the factory jack is located under the rear passenger seat. To access it, lift the seat cushion upwards, and you'll find the jack stored in a compartment beneath the seat. Make sure to secure the seat back in place after retrieving the jack.
In a 2003 Toyota Sequoia, the jack is located in the rear cargo area, specifically under the floor mat. To access it, lift the rear cargo floor panel, and you will find the jack stored in a compartment along with other tools. Make sure to check the owner's manual for detailed instructions on how to safely use the jack.
To replace the drive shaft bushing in a 1992 Toyota Previa, start by safely lifting the vehicle and securing it on jack stands. Remove the drive shaft by unbolting it from the differential and the transmission, then slide it out. Take out the old bushing using a suitable tool, such as a bushing removal tool or a hammer and drift, and press in the new bushing. Reassemble the drive shaft by reversing the removal steps, ensuring all bolts are torqued to the manufacturer's specifications.
In the 2007 Toyota Tacoma, the jack kit is located under the rear passenger seat. To access it, lift the seat cushion, and you'll find the jack, tire iron, and other tools stored in a compartment. Ensure the seat is securely in place after retrieving the kit.
The Jack is stored under the Hideaway Spare in the trunk. There should be a sticker showing how it's stored.
Jack Sensenbrenner died in 1991.