down there under the hose to the left between the wires over the top of the other hose that goes around the wire harness.
i need to locate knock sensor on a 2000 infiniti g20
donde esta colocado el knock sensor en una Chevy silverado 2000
Need to know the engine size. You will need to ask your question again.
Trouble code P0330 means: Knock Sensor 2 Circuit (Bank 2) Replace the knock sensor
Underneath the intake manifold there will be two knock sensors
Behind the starter.
The knock sensor is basically a one inch thick washer with a sensor plug on it. it will be attached to the block with a bolt that just runs through the center of it The knock sensor module is located inside the little cover on the VCM.
On V6 models, the knock sensor is located on the front (radiator) side of the engine block above the oil filter.
by oil filter
The knock sensor is on the right side of the motor on the block .It runs under the manafold.I can not get the retaining clip off.MIKE
The knock sensor is located on the front (radiator) side of the engine block above the oil filter The knock sensor is located on the front (radiator) side of the engine block above the oil filter
It is located on the engine block drivers side.