The knock sensor on a 1995 Oldsmobile Regency 98 with a 3800 engine is typically located on the engine block, specifically on the lower part of the engine, near the oil pan. It is positioned on the driver's side, towards the rear of the engine. To access it, you may need to remove some components for better visibility and ease of reach. Always refer to a service manual for precise location and removal instructions.
I believe it is located underneath the front bumper.
The knock sensor is located on the 95 oldsmobile 98 with a 3800 engine under the midpoint of the heads.
On a 91 regency it's located in the center under the hood near the hood latch assembly!! Dave
There are two for the engine - they are under the intake plenum attached to the engine. There is one outdoor sensor located in the front of the car - under the facia, and there is one for intake air located in the air - cleaner box.
The 1995 Oldsmobile Aurora 4.0 liter engine crank sensor is located on the back of the crank. You will need to remove the rear engine cover in order to view the crank sensor.
check water in plastic water box right side of engine compartment. that's where sensor is
Where is the Knock Sensor located on a 1996 Oldsmobile Aurora?
The ETC sensor on the 2002 Olds 3.5 engine is located at the right rear of engine, below the throttle body at the head not the block.
under the power steering pump in the top of the engine.
The 1984 Cutlass is a model of car produced by the company Oldsmobile. The oxygen sensor is typically located near or on the engine block.
where is the crank sensor located at on a 1996 cutlass ciera wit a 3.1 engine
The throttle positioning sensor is located in the throttle body.