0
just removed mine it is hiden behind the emegency brake pedel you must remove the left f tire then remove the wheel well liner at least the rear of the liner pull the liner forward the ecm is in the firewall 2 /11 mm nuts hold it in place one 10 mm bolt holds the conector also you can see it from under the hood far left side to the left of the main wiring conctor
What else can I help you with?
Where is the pcm located on a 1989 ford bronco?
The PCM for the 89 Bronco is located on the firewall on the driver side. You can access it from inside the cab, behind the parking brake pedal.
1996 ford thunderbird pcm power relay location?
1996 ford thunderbird pcm power relay location?
How do you reprogram a pcm for Chrysler 1996 town and country?
A pcm is programmed with a flash capable scan tool.
Where is pcm on 1996 Pontiac sunfire?
According to my Hayes repair manual the PCM is located inside the right front fender.
Need a 96 neon pcm wire diagram?
Need a 1996-1999 Wiring diagram for PCM for dodge neon
How do you disable the speed warning on a 1996 Caprice?
A tuning program for the PCM is the correct answer, PCM For Less can do it for you quickly and at a reasonable price.
Where is the voltage regulator on a 1996 Jeep Cherokee Clasic located?
PCM
Where is the pcm located in a 1996 impala ss?
Hi there. Your PCM is located in the front left engine compartment under the air filter housing.
Where is the pcm on a 1996 Chevy Cavalier?
The PCM is located in the right corner of the engine compartment under the air cleaner assembly and bolted to the chassis
How do you match up a 1996 Dodge Neon 2.0 SOHC AT PCM for compatibility with salvage yard PCMs?
You could take the old PCM with you to the salvage yard. There is a sticker with a part number on the bottom or side of the PCM. You will need to remove the PCM to see it.
How do you adjust RPM for the 1996 mercury villager?
Idle speed is set by the PCM and IS NOT ADJUSTABLE.
1996 Taurus pcm will not communicate with scan tool you have checked fuses and pcm and power to dlc?
If you have continuity from the DLC back to the PCM on all the pins that it should, and the PCM has power and ground everywhere it is supposed to, you probably need a PCM. Before I throw a PCM at it though, I would make extra sure that you have checked all of the stuff that I spoke of first. Remeber the PCM will have more than one power and more than one ground input.
