0
The map sensor on Safari 4.3 L and Astro vans are accessed through the inside engine cover. Once you remove the engine cover you can spot the air intake for the throttle body . The map sensor is to the right of the air intake (passenger side) about 2 - 3 inches, towards the rear of the van
What else can I help you with?
Where is the crank shaft position sensor on a 1999 gmc safari van?
The CPS is located on the front of the engine attached to the harmonic balancer on the front of the crankshaft.
Where is the fuel pressure regulator on your 1999 gmc safari?
where is the fuel pressure regulator on a 1999 GMC SAFARI? thank you
Where is the knock sensor located on a 2002 GMC Safari?
behind left valve cover should be round
Where is the camshaft sensor located on a 1999 gmc savanah?
in the gas tank
What is the mileage rating of a 1999 gmc safari van?
We currently get 17 mpg. We have a 1999 GMC safari van with 177000 miles on it.
Where is the temperature sensor located on a GMC Safari?
Ah, the temperature sensor on a GMC Safari is typically located near the engine block or on the radiator. It's a crucial part that helps your vehicle maintain the right temperature for optimal performance. Just like adding a happy little tree to a painting, taking care of your temperature sensor will ensure your Safari runs smoothly on its journey.
What type 02 sensor is on a 1999 gmc safari van 4.3?
You might not have to replace it. Make sure your gas cap is on to where it seals right.
Where is crankshaft position sensor located on 2000 gmc safari awd 4.3 engine?
Front, lower, passenger side of engine.
Where is the pcm located on a gmc safari?
I have a 1998 gmc safari awd van & my pcm is located under drivers seat bolted to the floor.
Looking for 1996 GMC Safari owners manual?
Whrere is the spare tire located on a 1996 GMC Safari?
Where is the map sensor located in 2005 gmc envoy?
where is the map sensor located on a 2005 gmc envoy
Replace fuel sensor for 2000 GMC Safari?
Do you mean fuel sender? If you do it's located in the fuel tank and is a complete unit (pump & sending unit).
