0
The Map Sensor on that model is located on the passengers side of the motor. It is on top of the plastic intake plenum and has a plug in connector. It is labeled "Sensor Pressure and has a part number of 09359409". BE CAREFUL REMOVING IT. It has a rubber gasket so wiggle it out. I have broken a few trying to remove them. It is held in place with a plastic clip connector.
What else can I help you with?
1994 Pontiac Bonneville?
where is a map sensor loction for 1994 ponatic bonneville?
Where is the map sensor locate on a Bonneville?
one location of map sensor on some pontisome Pontiac Bonneville,s map sensors are located in the vicinity of the pcv--valve, over top of it , depends on year.
Is there a fusebox located under the back seat of a 1994 Pontiac Bonneville?
sensor de map
Where is the location of the map sensor on a 1990 Pontiac Bonneville?
Small black box mounted onto the throttle body.
Where is the PCV on a 1995 Pontiac Bonneville?
On a 98 it is in the plentum on the passenger side under the map sensor. turn the map sensor 90 degrees and pull straight up.pcv should be underneath.
How do you replace map sensor on 2001 Pontiac Bonneville?
First locate map sensor,on top of throttle body it's held on by two star bit set screws. After removing and then unplugging make sure surface is clean and add a little electrical contact lube. Install
What does the map sensor for your Pontiac Bonneville do?
The map sensor (Manifold Absolute Pressure sensor) in a Pontiac Bonneville measures the pressure inside the intake manifold. This information is crucial for the engine control unit (ECU) to determine the air density and calculate the correct fuel-to-air ratio for optimal combustion. By providing real-time data, the MAP sensor helps improve engine performance, fuel efficiency, and emissions control. A malfunctioning sensor can lead to poor engine performance and increased fuel consumption.
Where is the PCV valve located on 1998 Pontiac Bonneville?
You can find the PCV valve beneath the MAP sensor located in the plenum at the right front of the engine.
What does map sensor run on a 2003 Bonneville?
about $50
Replacing 1999 Pontiac Grand Am MAP sensor?
were is my 1999 pontiac grand am map sensor location
Where is a map sensor located on a 2000 Bonneville 3.8?
On a 2000 Pontiac Bonneville with a 3.8L engine, the manifold absolute pressure (MAP) sensor is typically located on the intake manifold, near the throttle body. It is mounted directly to the manifold and connected by a vacuum line. You may need to remove some engine covers or components for better access when inspecting or replacing the sensor.
How do you install map sensor in 2001 3.4l v6 Pontiac grand am gt?
To install the MAP sensor on a 2001 Pontiac Grand Am GT with a 3.4L V6 engine, first, disconnect the negative battery terminal to ensure safety. Locate the MAP sensor, which is typically mounted on the intake manifold. Remove the electrical connector and the retaining bolts, then take out the old sensor. Install the new MAP sensor by reversing the process: secure it with bolts, reconnect the electrical connector, and finally reconnect the negative battery terminal.
