0
In a 1983 Oldsmobile Delta 88, the oxygen sensor is typically located on the exhaust manifold or just downstream of it in the exhaust pipe. It may be found near the catalytic converter if the vehicle is equipped with one. If you're having trouble locating it, consulting the service manual for your specific model can provide additional guidance.
What else can I help you with?
Where is the engine coolant sensor located on a 1983 Oldsmobile delta 88?
On a 1983 Oldsmobile Delta 88, the engine coolant temperature sensor is typically located near the thermostat housing or on the engine block itself. It is usually found in the vicinity of the intake manifold, often on the driver's side. To access it, you may need to remove any obstructions, such as wiring or hoses. Always consult a repair manual for your specific model for precise location and removal instructions.
Where is the starter relay switch located on a 1983 Oldsmobile Delta 88 And how do you change it.?
It's ontop the starter and has been for years and it's called the starter solenoid. You send 12 volts to it when you crank the car.
Where is fuel filter for 1983 Oldsmobile delta 88?
The fuel filter for a 1983 Oldsmobile Delta 88 is typically located along the fuel line, either near the fuel tank or along the chassis under the vehicle. It may also be found near the engine, depending on the specific configuration. To access it, you may need to raise the vehicle and inspect the fuel lines. Always ensure safety precautions are taken when working on fuel systems.
Where is the thermostat on a 1983 oldsmobile delta 88?
Should be located in a removable housing at the engine end of the upper radiator hose.Should be located in a removable housing at the engine end of the upper radiator hose.
Where is the water temp sensor located on 1983 ford bronco six cylinder?
The temp sensor is located on the intake manifold
What type of engine is in a 1983 Oldsmobile delta 88 royale?
If the engine is stock it is either a 3.8 V6, 5.0 V8, or a 5.7 V8 diesel
What is the bolt pattern of a 1983 delta 88?
The bolt pattern for a 1983 Oldsmobile Delta 88 is 5x115 mm. This means it has five bolt holes arranged in a circle with a diameter of 115 mm. Always verify with a reliable source or check your vehicle's specifications, as variations can occur depending on specific models or modifications.
How to replace crankshaft position sensor on a 1983 mercury grand marquis 302 v8 engine?
1983 doesnt have a crankshaft position sensor. you have an ignition module located on the side of the distributor.
Where is the fuel pump on a 1983 Oldsmobile Delta 88?
On the lower left side front of the engine it is a gold copper color and it bolts to the front of the engine right behind the drive belt.
When was Delta Drawing created?
Delta Drawing was created in 1983.
When was The Delta Star created?
The Delta Star was created in 1983.
How do remove and replace the ignition switch of a 1983 Oldsmobile Regency?
How do remove and replace the ignition switch of a 1983 Oldsmobile Regency?
