0
What else can I help you with?
How do you change oil sensor on 1996 Chevy s10?
If that S10 has a 4.3 engine, I find it best to remove the distributor to gain better access to the oil pressure sensor.
What is the location of the oil pressure sensor in a 1991 s10 blazer?
it is under the distributor.
Where is the oil pressure sender on a 1983 Chevy S10 truck 2.8 liter engine?
Right by your oil filter
How do you find the oil pressure sensor on a 96 Chevy S10 Blazer 4.3 6 cylinder engine?
It is about 3 inches long with an electrical connector on the end of it. It is back by the right hand side of the distributor. Hard to see.
Where is the oil pressure switch located on a 2000 Chevy S10?
I`m not sure if the swith is the same on a 2000 S10 but the 93`s have it mounted to the oil filter housing.I you.
How do you test a 4.3 chev oil pressure sensor?
If it is a 1997 S10 4.3, with the engine running, remove the fuel pump relay, if the engines stops running, the oil pressure sensor is bad.
What is normal oil pressure on a 2002 Chevy S10 V6?
The normal oil pressure on a 2002 Chevy S10 V6 is around 40 PSI. This will vary slightly depending on the temperature of the engine. Hot at idle in drive, 20 psi is also normal.
Where is the MAF sensor located on a 1994 Chevy s10?
The 1994 S10 uses a MAP sensor, not a MAF sensor. We need to know size engine you have in that S10.
Where is the oil pressure sending unit located on a 1988 Chevy s10?
At the rearmost section of the engine to the right of the distributor.
What cause 2001 Chevy s10 to have low oil pressure?
antifreeze leaks by the intake gasket into oil. deteriating bearings causing oil to leak by the bearing
What is the normal oil pressure for a 2001 Chevy s10 pickup 4 cylinder?
Hot at idle, 20-30 psi.
Does 94 Chevy s10 have crank sensor?
Was not used in that year.
