Itis located on the back of the block, just to the passenger side of the distributor.
The oil pressure sensor on the 360 V8 is on the top rear of the engine, next to the distributor.
It does not have a mass airflow sensor.
It is next to the thermostat housing.
The engine temp sensor is on the front of the engine, next to the thermostat housing.The engine temp sensor is on the front of the engine, next to the thermostat housing.
It is on the back of the engine, just to the side of the distributor.
Rear of engine block, behind intake, next to distributor
The crankshaft position sensor on a Dodge 5.9L V8 is located behind the passenger side cylinder head, and it aims at the flywheel through a hole in the bell housing.
It is on the back of the engine, just to the side of the distributor.
It is on the back of the engine, just to the passenger side of the distributor.
On a 1987 Dodge 360 engine, the water temperature sensor is typically located on the intake manifold, near the thermostat housing. It is usually threaded into the manifold and connected to the wiring harness that relays temperature information to the gauge on the dashboard. Always ensure to consult a repair manual for precise location and specifications for your specific vehicle model.
As with most engines, the Dodge 360 cid engine's crankshaft rotates clockwise when viewed from the front of the engine. The distributor also rotates clockwise.
Of the 16,437 Dodge Challengers sold in 1974, 6,063 had the 360 engine.