answersLogoWhite

0

Under the intake manifold, near the end of the starter.

Under the intake manifold, near the end of the starter.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

Where is the oil pressure sensor switch on a 2008 dodge caliber?

The oil pressure sensor on a Dodge Caliber is under the intake manifold on the front of the engine.


Where is the oil pressure sensor switch on 2007 Dodge Caliber?

On the front of the engine, under the intake manifold, behind the ac compressor.


Where is the fuel pressure switch on a Dodge Durango?

Dodge Durango is not equipped with a fuel pressure switch


Where is the Transmission fluid pressure switch located on a 2002 dodge ram?

Located on the valve body inside the transmission.


Where is the AC low pressure switch on a 1995 Dodge 1500 Ram pickup 318?

The 1995 Dodge 1500 RAM pickup truck air conditioning low pressure switch is located on the top of the accumulator.


Where is the fuel shutoff switch on a 2009 dodge caliber?

Dodge does not use inertia/reset switches.


Where is the leak detection pump pressure switch located on 1999 Dodge Intrepid?

The leak detection pump switch on your Dodge Intrepid is located beneath the battery. If you can not locate this on your own, it may be best to have a licensed mechanic take a look at it.


What should the tire pressure be on a dodge caliber 2008?

the correct tire psi is 32 for the caliber 2008


Where is the oil pressure switch located on a dodge Dakota?

Located on the engine block. The exact location varries. A service manual would show you where.


Where does the reset engine firing switch located in a 95 dodge stratus?

Dodge does not have a reset switch.


Is the oil sensor in located on the oil pump on a 98 dodge Dakota 3.9 v6?

The oil pressure switch is next to the distributor on the back of the block.The oil pressure switch is next to the distributor on the back of the block.


Where is oil pressure switch on 1999 dodge dakota?

It is located on top, at the back of the motor near the distributor. It is screwed into the block vertically.