answersLogoWhite

0

The oil temp sensor on a 1991 Chevy Corvette is located on the bottom of the engine, near the oil pan. It constantly monitors the temperature of the oil and relays information to the computer.

User Avatar

Wiki User

11y ago

What else can I help you with?

Related Questions

Where is the oil sender 85 Corvette?

The pressure sender is on the rear of the block, on the top...mounted on an "L" tube near and kindoff under the distributor. The oil temp sensor is on the side of the block, I forget exactly where...sorry. There is also a water temp sensor and a detonation sensor on the sode of the block....


How do you change the oil temperature sensor on a 1985 corvette and where is it located?

The oil temp sensor is located just above the oil filter..To change just unscrew the old sensor and screw in the new sensor , then reconnect the wires .. You should use a sealant on the threads that is sensor safe so you have a good ground..WW


Where is the temp sensor on a 93 northstar?

Which temp? Oil, Water or Outside air?


Why does your 1998 Corvette continue to blow the oil sensor pressure gage?

== ==


Where is the oil temperature sensor located on a 1986 Corvette?

Right above the oil filter , in the engine block.


Why is it important to know the cause of an oil rise?

my 1985 corvette oil temp rise to 300degree while driving for a short distance


Where is the sensor 1995 neon?

There are several sensors on a 1995 Neon. The water temp sensor, crank shaft position sensor, and oil temp sensor are all mounted at various places on the engine block.


Where is the oil temperature sensor on a 1986 Corvette?

It's above the oil filter and below the ground bolt on the side of the block.


Oil pressure is reading high on corvette but oil is at correct level. Does this indicate a bad sensor switch?

High oil pressure is good....


Where are the locations at to hook up aftermarket gauges on a 2000 Grand Prix GTP oil boost oil temp and water temp?

Your oil temperature gauge will connect to the oil pressure sensor. The water temperature gauge will hook up to the water temperature sensor. The oil pressure sensor will be on the left-hand side of the engine and the water temperature sensor will be on the front of the engine.


Where is the oil sensor on ford ranger 1991?

If your looking for the oil level sensor it would be located on the driver side on the oil pan.


Where do you install a Oil Temp Sensor on a 350 block?

hmmm, I've never had an oil temp sensor. I've only had an oil pressure unit, on the back of the block behind the distributor, and a block/coolant temp located on either head, one of my cars have even had one in each head. my 2cents :)