answersLogoWhite

0

In the exahust manifold, possibly left, but generally on the right exaust manifold.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Where is the oxygen sensor located on a 1994 Ford F-250?

on the exahaust manifold


Where is the oxygen sensor located on a F- 250 ford with a 460 engine and floor shift 4 x 4?

Please provide the year the truck was manufactured.


Where is the speed sensor located on a Ford F-250?

It is located on top of rear axle in center.


Where is the intake temperature sensor on your 1991 ford f-250?

The air intake sensor on a 1991 Ford F-250 is located on the top of the engine. It is mounted just behind the distributor.


Where is the speed sensor located on a 1996 ford F-250?

Should be on top of the rear axle of your truck.


Where is the fuel sensor gage located in 87 Ford F-250 not the dashboad one either?

in the tank


Where is the speed sensor located on a 2000 Ford F-250?

On the top of the transmission, above the output shaft.


Where is oil pressure sensor located on Ford F-250?

The oil pressure sensor on an f250 engine is located at the back toward the firewall. It is centered side to side close to the intake.


Where are the oxygen censors located at on a 2002 Ford F-250?

Under the back bumber outside the car. It must be running in order to produce oxygen


How do you located a speed sensor in the ford E-250?

Usually, this is located in the top of the rear differential. While you're there, check for any sparklies in the gear oil.


Where is crank sensor on 1996 Ford F-250 5.8?

What position is the crank sensor on a f250 ford pickup


How do you change oxygen sensors on a 1998 ford econoline E-250?

To change the oxygen sensors on a 1998 Ford Econoline E-250, first, locate the sensors; there should be one before the catalytic converter and one after. Disconnect the battery to ensure safety, then unplug the electrical connector from the sensor. Use a specialized oxygen sensor socket or a wrench to remove the old sensor, then install the new one by threading it in and tightening it securely. Finally, reconnect the electrical connector and the battery.