Near the "Y" pipe to exhaust manifold joint. Follow the wire that is the same color as the replacement part has. It screws into the pipe just like a sparkplug. You will need a 7/8" wrench or an O2 sensor socket to remove & install the part.
where is the oxygen sensor in a 1995 gmc jimmy
The upstream oxygen sensor is mounted in the exhaust manifold The downstream oxygen sensor is mounted in the exhaust pipe after the catalytic converter
With an o2 sensor socket.
No it will not.
The 1995 model did not use a Idle air tempture sensor ( IAT ) Did not need one for that fuel system.
That year did not have a Manifold Air Tempture sensor / MAT sensor, no need for it on the Throttle body injection system.
on the header
labor cost to change an oxygen sensor in a 1995 toyota avalon
The service department will put in a new oxygen sensor, with a 25% discount on parts if you are a Chrysler employee, for $102.**. The sensor, with the discout, is @ $95.
The oxygen sensor is screwed into the exhaust manifold on the rear of the engine on a 1995 Chrysler Town and Country.
It will require a special socket with a slot down the side so as not to damage the wiring. It may be cheaper to have a shop do it as the sensors do not go bad very often.
A 1995 ram only has one sensor. It is on the right side directly in front f the catalytic converter