answersLogoWhite

0

The Powertrain Control Module (PCM) on a 1997 Chevy 1500 is typically located in the engine compartment. It is commonly situated near the firewall on the passenger side, close to the bulkhead. The PCM is housed in a protective case with electrical connectors and is mounted securely to the vehicle's body or firewall. To locate it, open the hood and look for a rectangular-shaped box with wiring harnesses connected to it. Consult the vehicle's service manual for precise details, as the exact location can vary depending on the specific model and engine configuration.

User Avatar

leepudamaxim

Lvl 4
1y ago

What else can I help you with?

Trending Questions
What is prominent cardiac silhouette? How do you replace the ball joints on a 1997 Chevrolet Monte Carlo? 1998 Chevy Monte Carlo 3.1 crank no start you have no spark no injector pulse changed crank sensor camshaft sensor and pcm What is wrong? Which car did the LS1 engine was first factory installed? How much is it to fix a transfer case on a 2004 Mercury Mountaineer? What are the causes of a blown head gasket on a 1997 Buick Le Sabre? What is the fuel consumption for a ford ranger 4000 v6 supercab cab 2wd? Where is the fuse box for a 1994 Jeep Laredo? Where is the flasher relay on a 1999 Ford explorer. I lost both turn signals and my emergency flashers but the bulbs and fuses are good? How do you remove broken spark plugs on dodge? How hard is it to change out a starter on 96 ford ranger? What would make a fuel pump run all the time? Where is the flasher unit located in a 1993 Subaru Impreza Sedan? What is the definition of a servo pressure regulators? Where can the airbag module be found on a 1999 Jeep Wrangler? Is there a method to repair the passenger side mirror glass without replacing the whole mirror unit? Why does your heater only work on high in a 1997 dodge cargo van and not on low? How much horsepower does a 2007 Yamaha grizzly 350 have? How do you change a bulb in gear shift on falcon au? What causes a rattling noise in the front end of a 2000 Chevy S-10 after replacing the upper and lower ball joints and every thing is like new but it still sounds like the upper ball joint is bad?