0
the sensor is located inside at the base of the windshield, in front of the defroster vent. It looks like a small hole. The newer ventures have 2 holes (one is for the security blinking light)
If you are trying to disable the daytime running lights and automatic headlights, then remove the fuse named "DRL"
What else can I help you with?
Where is the fuel cut off switch in a 2003 Chevy venture van?
it does not have one.
Where is the fuel pump safety switch on 2000 Chevy venture?
GM vehicles do not have a fuel shut off/inertia switch
How do you get the interior lights to go off on a 2001 venture Chevy van.?
there is a switch on the ceiling of the van
2001 Chevy Venture oil pressure switch?
on top of the starter of front of your engine block
Where is TCC switch located on a 1999 Chevy Venture?
its on left side of trans behind side pan
How do you change window switch on passenger side Chevy Venture?
just pull the switch board out then there is a cable in the board just pull it out to diss connect it
Where is the relay switch for head lights located on a 1998 Chevy venture?
check the fuse box on top of the battery.
What type of antifreeze do you use in a 1998 Chevy venture minivan?
Was built with Dexcool. A lot of people switch to green.
How do you reset the fuel pump on a 2000 Chevy venture?
There is no reset switch. The fuel system is computer controlled with relays.
How do you Unlock the radio in Chevy Venture?
How do you unlock the radio of. 1997 Chevy venture
Where is the oil pressure switch located on a 2002 Chevy venture?
it may be in back corner of engine, passenger side lower.
How do you remove the headlight switch from a 2003 Chevy venture van?
To remove the headlight switch from a 2003 Chevy Venture van, first, disconnect the negative battery cable to ensure safety. Then, use a flathead screwdriver to gently pry off the decorative trim around the switch. Next, remove any screws securing the switch, disconnect the wiring harness from the back, and finally pull the switch out of the dashboard. Reinstall the new switch by reversing these steps.
