0
What else can I help you with?
How do you replace a 1998 Cadillac deville power antenna?
how do you replace power antenna on 1988 deville
Where do you put in the power steering fluid for an 1988 cadillac?
I have an 1988 Deville. On my car the power steering pump is on top of engine next to the belt tensioner. You will see a reservoir with a plastic cap . Remove cap and put fluid in there.
Where is the pcv valve located on a 1988 Cadillac DeVille?
Directly behind the power steering pump. There is a 5/8th hose, pull up from valve cover.
Does 1991 Cadillac deville engine fit a 1988 Cadillac deville?
yes.
How do you install a switch interruptor commutateur for a 1988 Cadillac deville?
What is location of switch interrupter on 2001 Cadillac deville
What is the fuel tank size on a 1988 Cadillac sedan Deville?
The fuel tank on a 1988 Cadillac Sedan DeVille holds approximately 18 gallons of fuel.
How do you change a 1988 Cadillac sedan deville headlight switch connector?
how do you take out a headlight switch's in a 1998 cadillac deville?
What size dash speakers are in a 1988 cadillac deville?
4x6
How do you take off the Steering Column Cover of a 1988 Cadillac DeVille?
You need a special tool for the telesopic steering column. It use to be available only to dealers, but I'm sure you can rent one these days.
What transimssion fluid does a 1988 cadillac deville take?
Dextron-Mercon
Where is the oxygen sensor on a 1988 cadillac deville?
The oxygen sensor in a 1988 Cadillac Deville is located in the exhaust manifold. It constantly monitors oxygen levels in the exhaust to allow the engine to operate and peek efficiency.
How do you put the steering column back together on a 1988 Cadillac deville?
To reassemble the steering column on a 1988 Cadillac DeVille, start by ensuring all components are clean and free of damage. Align the ignition switch and the turn signal mechanism with the column casing, then insert the wiring harness and secure it in place. Reattach the steering wheel by aligning it with the shaft and tightening the retaining nut. Finally, reattach any covers and ensure all connections are secure before testing the functionality.
