Up till 2004 it was next to the battery. After it is inside the driver side fender, remove plastic liner to access.
The relay switch on a 1997 Chrysler Town and Country mini van is located on the front bumper reinforcement. It is controlled by the PCM (Powertrain Control Module).
internal to the engine computerThe voltage regulator on a 2000 Chrysler Voyager is located within the Powertrain Control Module. If you want to replace the voltage regulator, you have to replace the PCM.
The powertrain control module (PCM) on a 2001 Chrysler PT Cruiser is typically located in the engine compartment. Specifically, it can be found on the driver's side, mounted on the firewall near the battery. Accessing it may require removing some components for better visibility and reach. Always consult the vehicle's service manual for specific instructions and safety precautions.
A 2001 Chrysler Town and Country does not have a water control valve in the heater system. The cabin temperature is controlled with electric motors on airflow control doors.
Powertrain Control Module (PCM)
in glove box
The powertrain control module, is located on drivers side under dash, it is white!
The front control module is part of the under hood fuse box on a Chrysler 300.
It is located in front of the left front tire. Remove the inner fender liner to access.
The Powertrain Control Module (PCM) on a 2000 Chrysler Concorde is located in the engine compartment, specifically on the driver’s side near the firewall. It is usually mounted to the bracket that holds the fuse box. To access it, you may need to remove some components or covers for better visibility.
attached to or adjacent to the fuse block assembly.
PCM powertrain control module is located on the firewall on the passenger side. it has 3 large wire connectors.