assume you mean Brake PDV... is located on the frame directly below the master cylinder.
The low pressure valve for charging the air conditioning system on a 1988 Pontiac Sunbird is typically located on the accumulator, which is found near the firewall on the passenger side of the engine compartment. The valve is usually covered with a plastic cap and is smaller in diameter compared to the high pressure valve. Make sure to identify the correct valve before charging the system to avoid any mishaps.
were is the fuel regulator located on a 1988 chevrolet celebrity ? The fuel pressure regulator is located under the intake manifold on the 2.8 V-6 engine but the pressure (Schrader type) test valve port is on the front of the engine to the right and just below the oil filler cap.
right in front of the compressor the alternator is right below it take off the black cap and there it is
The 1988 Chevy Corsica air conditioning service valves can be found on top of the air conditioning compressor. The air conditioning service valves are labeled as the low pressure valve and the high pressure valve.
Facing the front of the truck, it is located on the intake manifold on the right side of the carb.
Fuel Pressure Regulator is located on the fuel rail.
The vehicle speed sensor is located at the rear differential on a 1998 Bronco II. This also serves as the ABS sensor.Ê
It should be at the base of the throttle body.
On a 1988 Honda Prelude, the hose connected to the PCV (Positive Crankcase Ventilation) valve is typically located on the valve cover. It runs from the PCV valve, which is situated on the driver's side of the engine, to the intake manifold. Ensure to check for any signs of wear or leaks in the hose, as it plays a crucial role in the engine's ventilation system.
It is located in the top of the motor with a rubber tube/hose going to the air cleaner I believe.
Low pressure side of compressor (larger hose)
Directly behind the power steering pump. There is a 5/8th hose, pull up from valve cover.