0
Where is the purge valve sensor located on a 2000 Chevy prism and is it easy to replace?
Where is it located? It is under the rear of the vehicle almost directly under the muffler next to the charcoal canister.
Is it easy to replace? That depends! It isn't particularly difficult but it is in a confined space and does require patience some mechanical ability and a few specialized tools like 1/4 drive sockets, stubby screwdriver and box end wrenches.
The sensor is secured by two fasteners that require stubby Phillips #2 scredriver and box end wrenches or 1/4 socket drive. It is in a very confined space and will require you to twist, turn and curse getting a good shot at the securing hardware. The muffler and exhaust pipes are in the way and the repair manual says to remove them to gain better access. It can be done without removing the exhaust but it is almost certianly more difficult. Removal of the exhaust can be difficult and adds more complexity.
What else can I help you with?
How do you replace coolant sensor in a 2001 Chevy prism?
Type your answer here... where is the coolant sensor ona 2001 chevy prizm
Where is the afm sensor on 1990 Chevy S-10?
how do you install a 1994 Chevy prism ignition
How do you Replace wheel bearings on 2001 Chevy prism?
With the correct tools
How do you install crank sensor 2000 Chevy prism?
To install the crankshaft position sensor on a 2000 Chevy Prism, first, ensure the engine is cool and disconnect the negative battery cable. Locate the crank sensor, which is typically found near the bottom of the engine block, and remove the mounting bolt. Disconnect the electrical connector and replace the old sensor with the new one, securing it with the bolt and reconnecting the electrical connector. Finally, reconnect the battery and check for proper operation.
Where is the fuel pump located on a 1999 Chevy prism?
In the fuel tank
How do you replace the light bulb of the headlight on a 1998 Chevy Prism?
the headlight assembly needs to come out in order to replace the bulb.
Where is the starter located in a 1998 Chevy prism?
the starter is located under the intake manifold you can't miss it
How do you fix the cruise control on a 2001 Chevy prism the light comes but it wont set the speed?
speed sensor
How do you replace the heater core on a 1995 Chevy Prism?
the library should have a shop manual to make copies of for your vehicle...:)
Why does the heater fan only works when the switch is in the high position of your 2002 Chevy prism not the first 3 positions?
replace the blower fan resistor located under the dash behind the glove box
How do you reset the o2 sensor on an 2001 Chevy Prism?
There isn't a reset for the oxygen sensors. When a repair is made then you need to have the computer cleared.jd
Where would a O2 sensor be located in a 1998 Chevrolet Prism?
There is one before the catalytic converter and one after.
