answersLogoWhite

0

If the cap on the Resoivoir twist or turns on says DO NOT OPEN HOT and there is no cap on rad then this is where you fill it at.

User Avatar

Wiki User

19y ago

What else can I help you with?

Related Questions

Where is the thermostat located on 2000 Ford Focus?

Follow the top radiator hose from the Radiator to the engine. The thermostat is locataed under the housing that bolts onto the engine


How do you download a picture of the location of the thermostat of a 2000 ford focus?

Normally the thermostat is located at the point where the upper radiator hoses connects to the engine.


Where is the radiator located on a 2003 Ford Focus?

You're kidding, right?


Where is the thermostat located in a 2003 Ford Focus?

In the top radiator hose fitting opposite the radiator, on the engine.


Where is the radiator drain plug located on your 2000 Ford Focus ZX3?

There is a screw that you loosen on the driver side on the inside (towards the engine) that you turn to drain the radiator. WE didn't think there was one but then we found it.


Where is the radiator petcock on 2000 Ford Focus?

it is at the bottom driverside of the rad, and its a hex nut


Where is the crash sensor located on a 2002 ford focus?

i do believe it is in front by grill and radiator


Where is fuse located to 2000 Ford Focus wagon No power to radio?

where is the radio fuse located in the panel box of a 2002 ford focus


How should cost a radiator in a Ford Focus?

The cost of a radiator in a Ford Focus will depend on the year of the car. A 2007 Ford Focus radiator will cost an estimated $63.66 at the website, CarParts.


Where is the water pump located in a 2000 ford explorer?

The lower radiator hose connects the radiator and the water pump


Where do you put coolant in on a 2000 Ford Focus?

Remove the radiator cap and add it directly to the radiator. Then fill the overflow reservoir to the full mark.


Where is the thermostat located on 2003 Ford Focus zx3?

On the opposite end of the top radiator hose, away from the radiator, in the inlet fitting.