In the trunk against the back seat. There is a plastic cover over it that has to be removed.
In a 2002 Cadillac DTS, the fan blower fuse is located in the fuse box under the dashboard on the driver's side. To access it, you'll need to remove the cover of the fuse box. The specific fuse for the blower motor is usually labeled in the diagram on the cover or in the owner's manual. If you're having trouble locating it, refer to the manual for detailed instructions.
I have a 2002 cadillac dts and the radio will not come on. Is there a code to reset it.
Look into the main computer, that's where alot of those problems originate!
Yes, a 2003 Cadillac Northstar motor can work in a 2000 Cadillac DTS, as both vehicles use the Northstar engine platform. However, you may need to ensure compatibility with engine management systems and other components, such as wiring harnesses and sensors. It's advisable to consult a professional mechanic to address any potential issues during the swap.
300hp
In the fuse box under the rear seat. Pull the seat up from the front (2 clips behind each of the front seats) and remove. Don't forget about the seat's electrical connector on the passenger side if you have heated read seats. The fuse box in on the drivers side of the vehicle. The 'Run' relay (position number 3) is the heated seat relay.
10g
i own a dts 2002 model, at 111 the top speed fuel cut off kicks in
There is a fuse box under the back seat. (You'll find the battery there too, by the way) Check fuse #23 (15A) for cigarette lighter and fuse #14 (20A) for additional power outlets.
Has anyone out there experienced my problem? After replacing a tire on 2006 DTS the service tire monitor system warning is on. I have relearned all tires okay, but cannot reset tire pressure sensors. Please help, I cannot afford service calls.
Take it to the dealership.
In a 2006 Cadillac DTS, the fuse for the lighter is located in the fuse box under the rear seat. To access it, you'll need to remove the rear seat cushion, which can be done by lifting it up to expose the fuse panel. Look for the fuse labeled "CIG" or "Lighter" in the diagram on the fuse box cover. If the fuse is blown, replacing it should restore functionality to the lighter.