Check #10 on the inside fusebox.
See "Related Questions" below for more
According to the 1999 Ford Windstar Owner Guide : " behind the access panel located on the right rear quarter panel interior trim "
On a 1999 Ford Windstar : What Ford refers to as the " service panel " is located in the cargo area on the passenger side of the vehicle
On a 1999 Ford Windstar, the expansion valve is located just inside the rear hatch of the rear panel on the driver's side. It is connected to the rear evaporator core.
On a 1999 Ford Windstar : ( relay # 207 is the fuel pump relay ) In the Power Distribution Box ( which is " live " ) located in the front of your engine compartment , near the battery
There is one circumstance that involves a fuse for BOTH speedometer and heater - a blown #10 fuse.This is also a very common symptom of a known defect on the Windstar involving a leaking brake sensor.See "Related Questions" and "Related Links" below
on the tranny
speed regulator sensor needs replacement
To turn off the speedometer alarm set at 75 mph on a 1999 Ford Windstar SE, first ensure the vehicle is in the "Run" position without starting the engine. Then, press and hold the "Set/Reset" button on the speedometer gauge until the alarm setting is reset or disabled. If the alarm continues, consult the owner's manual for specific instructions related to your vehicle's speed alert system.
There is no MAP sensor on a 1999 Windstar.
how to drain 1999 windstar
Generally speaking the seats from a 1999 Windstar will fit up to 2003 Windstars.
A speedometer on a 1999 Yamaha Roadstar 1600 might quit working due to a malfunctioning speed sensor, which is responsible for sending speed data to the gauge. Additionally, issues with the wiring or connections leading to the speedometer can cause it to fail. A broken speedometer cable, if equipped, could also be a culprit. Lastly, the speedometer itself may have internal faults that require repair or replacement.