answersLogoWhite

0

Answer

No button. You'll need to use an engine diagnostic scanner that has a little more functionality. Some of the better ones allow you to clear a code and reset the light. The cheaper ones just let you see the codes.

Answer

you need to take it to a auto shop and have then use there OBD2 SCAN TOOL then they can tell you why it came on and turm the engine light off


Answer
  • Scanner / code readers are not very expensive ($40) and very handy to have

  • Many auto parts store, i.e., O'Reileys & Autozone, will read the codes for free

  • Disconnect the battery for anywhere from 30 seconds to 20 minutes to reset the light

  • If the source of the trouble codes goes away, the light will go off after a number of "drive-cycles" all by itself
See "Related Questions" below for more
User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

What would you check for if the check engine light comes on in a 1992 mercury sable?

You must scan the computer to find out the code first Go to a qualified mechanic for a diagnostic


How do you determine which has the misfire when the check engine light flashing mean on 2000 mercury sable?

You have the code read with a scan tool to determine which cylinder.


2000 mercury sable and the check engine light is on you diagnostic checked it and the code was 171 It read systems lean Any suggestions?

Fuel filter


What is the code P1451 on a Mercury Sable?

Fallo la prueba de emision tiene el check Engine con el codigo p1451


How can you tell if the o2 sensor is bad on a 2000 mercury sable?

The check engine light would illuminate and set a code for the bad O2 sensor.


Blinking check engine light on 2002 mercury sable?

If your check engine light is blinking that means an engine cylinder misfire has been detected - have the vehicle scanned for any trouble code(s) to help diagnose and then repair the problem


2002 Mercury Sable idle rough when the ac is on?

check fuse 22


No heat in a 2000 Mercury Sable?

To fix the heat in the 2000 Sable, check the coolant level first. Make sure that the engine is not heating, if it is then the thermostat or water pump could be bad. These are the most common causes of heat being out.


What is the spark plug gap on a 2005 mercury sable 3.0?

spark plug gap on 2005 mercury sable 3.0 =========================================================== Check the Vehicle Emissions Control Information ( VECI ) decal located in the front of the engine compartment ( it will show what type of spark plugs to use and the spark plug gap )


How do i Change antifreeze on 2000 Mercury Sable?

Drain radiator, rinse with water or radiator cleaner, then refill. Don't forget to check the leve after running the engine a while.


Why does your 2002 mercury sable bucks while driving?

This could be a way of describing severe hesitation / engine misfiring. See "Related Questions" below for the basics of what to check for...


Why is the check engine light flashing in your 2003 Mercury Sable?

If the check engine light is flashing with the engine running that means that an engine cylinder misfire has been detected . You can still drive it in for repair , just avoid any rapid acceleration or deceleration because you can damage the catalytic converter