0
Well, hello there! The restrictor plate on a Tanaka 33cc engine is usually located near the carburetor. It's designed to limit the amount of air and fuel going into the engine, which can help control the speed and power output. If you're looking to remove it, just remember to do so carefully and make sure to follow the manufacturer's guidelines for optimal performance. Happy painting!
What else can I help you with?
Is the X-Racer 6 Human Transportation System electric?
NO it has a 33cc two stroke engine.
33cc of liquid drainage equals what in liters?
33cc = 0.033 liters.
33cc of liquid drainage equals what in ounces?
33cc is 1.12 fluid ounces.
How do you make a 33CC Gas-powered Scooter go faster?
== ==
Can you put a 49cc head on a 33cc crankcase?
Normally you cannot do this without modifications.
In Utah do you need a license to ride a 33cc scooter?
In Utah, you do not need a motorcycle license to operate a scooter with an engine size of 33cc or less. However, you must be at least 16 years old and have a valid driver's license. It's also important to comply with any local regulations regarding helmet use and equipment requirements. Always check for the most current laws, as regulations can change.
Is a 33cc gas powered scooter legal in Illinois?
yes it is very legal iam from there
How do you connect kill switch to 33cc gas scooter?
you run aline to the blak wire
What is the correct gap for a 16 inch 33cc homelite chainsaw?
.030. thirty thousandth.
Can you hook up a 12 volt light to a 33cc scooter?
Yes, if you have a 12 volt battery and/or a charging system to support it.
Will a 49cc motor fit on a 33cc scooter without a lot of modifications?
yer it should because it s very similer
Where is the idling screw on a 33cc zooma gas powered scooter?
It's the phillips screw where the throttle cable leads into the choke
