There is no sensor. There is a turn signal flasher relay and hazard flasher relay. They are located somewhere under the dash. Where I could not say. You just have to look for them. Look in your owner's manual, and it may list the location. If not go to www.autozone.com and use the component location tool.
The hazard flasher unit is located under the LH side of the instrument panel between the junction block and the brake pedal.
timing delay sensor
Your dood agar sensor sounds like it bad
A 1997 Chrysler does not have a MAF sensor.A 1997 Chrysler does not have a MAF sensor.
Traffic lights are programmed by a central computer - and they also receive signals from a sensor built into the road - to take account of he increased traffic flow at peak times.
A Chrysler LHS does not have a mass airflow sensor.
To replace a hazard light sensor or button, first disconnect the vehicle's battery to ensure safety. Remove the trim panel or cover surrounding the button, then disconnect the wiring harness attached to the button or sensor. Replace the old component with the new one, reattach the wiring harness, and reassemble any panels. Finally, reconnect the battery and test the hazard lights to ensure they function properly.
A 2002 Chrysler Sebring convertible does not have a maf sensor.
Distance indicators for the backup sensor system.
a 2003 Chrysler Town and Country does not have a mass airflow sensor.
A signal from the range sensor inside the transmission is passed from the transmission computer to the under hood fuse box. It turns the lights on.A signal from the range sensor inside the transmission is passed from the transmission computer to the under hood fuse box. It turns the lights on.
A 1996 Chrysler Sebring does not have a mass airflow sensor.