On the Impala the flasher is located behind the dashboard, just to the right of the steering wheel. You have to remove the dashboard to get to it. It square and about 2" long. To remove the dash:
- remove the two fuse compartments doors or lids, that are on either end of the dashboard. there are two screws to remove on both sides.
- Remove the kick plate beneath the dash on the passenger side.
- Remove screws beneath the dash on drivers side
- Adjust steering wheel to the full down position
- Move Shift lever all the way down
The flasher on most cars is located around the fuse box under the dash, or attached to the underside of the dash. It is a small round cylindrical Can made of aluminum, or plastic.
To replace the emergency flasher switch, there is no need to remove the front face of the dash. Just use a flat head screwdriver to pop off the top of the flasher switch. Then use needle nose or channel locks to pull remainer of switch out so it can be unplugged and replaced. Plug in new switch, push back into place and you are ready for your turn signals and emergency flashers to work. It takes all of 5 minutes to do this.
The most likely cause is the turn signal flasher.
Where is the turn signal flasher on a 2004 ventra van
do you need to remove dashboard in 2003 chevy impala to replace heater core
The 2003 Impala has a 17 gallon fuel tank
Most blinker circuits do not flash if one bulb is burned out. If the bulbs are all OK then the flasher is probably bad.
The turn signal/hazard flasher is integrated into the flasher switch. A very common failure on these cars.
how do you fix turn signal
2003
check with your Chevy dealer on that.
Fix a "door ajar" on Chevy Impala 2003 . Still on doors closed.
The flasher relay on a 2003 Chevy Malibu is located under the dash near the steering wheel. Look for a bright green plug.
Above the radio there is a button with red triangles on it. That is where the turn signal flasher is. You have to take the dash off to get to it.