I have a RV built on a 1994 E-350 Ford chassis with the 7.5 liter engine. I finally found the SPark OUTput (SPOUT) connector behind the driver side battery. It is a gray plug in a black socket. It was taped to the wiring harness that goes to the ignition control module (ICM) which is also behind the battery. The tape completely covered both the plug and socket making it very hard to find.
wer is the spout connector on 1992 ford e150 v8 5.0 liter
I'm not a mechanic / technician but I believe the spout connector is by your COIL PACK
where is the spout control on a 1992 ford f150 300 6 cyl
um just no
I believe it should be close to the distributor at the front of the engine
Its located on the passenger side fire wall near the shock tower
Driver side left fender about 8 inches below and left under diagnostic connector if your standing over it. Its grey.
The spout connector on a 1986 Ford LTD with a 3.8-liter engine is located near the ignition module or on the engine's wiring harness. It's typically a two-wire connector that can be found near the distributor or the firewall. This connector is used for setting the ignition timing by bypassing the computer's control. Make sure to consult the vehicle's service manual for precise location details.
Spout Spring is about 10-15 miles east of Lynchburg on state route 460.
its located just forward of the battery and just behind the left headlight. it has pink wires.
i have never heard of a spout connector. need more information - Its a little square gray plug with 2 wires going into it usually taped to the wires that go to your ecm - hope that helps
10 degrees before top dead center(BTDC) with the SPOUT connector unplugged.