answersLogoWhite

0

Under the oil pan joint level mounted into the transmission housing so it can engage the flywheel ring gear. The starter is accessed from under the vehicle. There are 2 bolts that attach the unit.

WARNING: The starter is connected to the battery with heavy high current leads that can carry dangerous currents. Always disconnect the battery ground terminal before working on or around the starter. Be sure the protective covers are in place before reconnecting the battery.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

How do you replace blower motor resistor on 2006 Ford Freestar?

where is the location for a blower motor relay on a 2006 ford freestar


How do you close the back windows on a 2006 Ford Freestar?

Switch on the center dashboard that says 'vent'.


Where is the starter on a 2005 Ford Freestar?

It's on the bottom of the motor, by the transmission case.


Can a 6 cylinder ford freestar pull 4000 pounds?

On a Ford Freestar : ( NO ) * according to the 2006 Ford Freestar Owner Guide , up to ( 2000 lbs if the factory trailer towing package is installed )


Where is the 3 spark plug on a 2006 ford freestar?

firewall 1-----2-----3 4-----5-----6 front of Ford Freestar > driver


How many watts does a 2006 Ford freestar block heater use?

I ASSUME the block heater in a 2006 Ford Freestar would use ( 600 watts ) like my Ford Explorer 4.0 liter V6 engine does


When was Ford Freestar created?

Ford Freestar was created in 2004.


Your ford freestar wont start?

2007 ford freestar


Where is the starter solenoid on a 2006 Ford Freestar?

The starter solenoid is an integral part of the starter motor. The starter is mounted on the engine and is accessible from under the vehicle. CAUTION: The starter input battery lead is energized at all times. Before working on the starter, be sure to disconnect the battery ground cable. Also be sure to reinstall the insulating covers on the terminals.


How do you change the starter on a 2005 Ford Freestar van?

To change the starter on a 2005 Ford Freestar van, first disconnect the negative battery cable to ensure safety. Remove the starter motor by unbolting it from the engine and disconnecting the electrical connections. Install the new starter by reversing the removal process, making sure to tighten all bolts securely and reconnect the battery cable. Finally, test the new starter to confirm it is functioning properly.


What is the best way to replace the back valve cover gasket on a 2004 freestar 3.9?

2006 valve cover. Gasket ford freestar 4.2 l


Where is cylinder number 1 on 2006 freestar?

On a 2006 Ford Freestar ( 3.9 and 4.2 liter V6 engines ) firewall 1-----2-----3 4-----5-----6 front of vehicle > driver