0
What else can I help you with?
Where is the O2 sensor located on a 2000 Chevy silverado 1500?
it's a 5.3 litre v8
Where is the crankshaft sensor on a 2000 Silverado?
I belive you may be asking where the crankshaft positoning sensor is, if so is is located behind the harmonic balancer. NEW ANSWER: That is true if it is a V6 engine, But if it is A V8 Then it is behind the starter.
Where is the map sensor located on a 2000 Chevrolet Silverado v8?
On a 2000 Chevrolet Silverado with a V8 engine, the map sensor (Manifold Absolute Pressure sensor) is typically located on the intake manifold, near the throttle body. It's usually mounted on the driver's side of the engine, attached directly to the manifold. You may need to remove some components or covers to access it easily. Always refer to your vehicle's service manual for precise location and removal instructions.
Where is the oil sensor unit on a v8 silverado?
depends what year - the oil level - condition sensor is in the side of oil pan
Where is the fuel pump for a 2000 Chevy silverado with a 4.8liter V8?
It is in the fuel tank.
Does a 2000 silverado 5.3 v8 have a block heater if so where is it?
NO it don't have one.
Where is the knock sensor on a 2005 silverado 5.3 v8?
There are 2 knock sensor under the intake manifold, You will need to remove the intake to get to them.
Where is Bank 2 Sensor 2 on a 1997 Chevy Silverado V8 5.7 located?
It's the sensor after the cat on the passenger side
Where is the knock sensor for a 2004 2500HD V8 6.0 Chevy Silverado?
There are two knock sensors on a 2004 2500HD V8 6.0 Chevy Silverado. Both of the sensors are mounted under the intake manifold on the engine.
How much horsepower does a 2000 silverado have?
5.3L V8 is 285 HP @ 5200 RPM
2000 silverado 5.3L v8 oil capacity?
6 QTS with a new filter.
Where is the crankshaft sensor on a 2000 Silverado V8 vortec?
it will either be on the front of the engine bolted to the block right near the damper pulley. if not the it is in the bell housing on the back of the engine. NEW ANSWER: On all V8 engine 2000 and up, It will be behind the starter. On V6 engines it is on the timing cover behind balancer. NEUTZ
