There are two:
Gauge and light:This sender is on the rear of the rear cylinder head toward the drivers side of the car. Sort of below the coil. Cooling fan control:This is a pain. It lives threaded into the intake manifold at the base of the thermostat housing, it has a single wire connector that pushes into it from the top.About 185F.
The temperature sending unit for this truck is located in the cylinder head on the right hand side at the very back (right behind the exhaust outlet for #6 cylinder)...... you out ...........
Yes, sort of, The clutch is different.
No the 1988 underwent a big upgrade
its located on the block on the drivers side just above the valve cover behind the a/c compressor and has a capped wire end attached to it.
5w30
5x100mm
On a 1985 Pontiac Fiero, the slave cylinder is located on the transmission, specifically mounted on the side of the transmission housing. It is accessible from underneath the vehicle, near the bellhousing where the transmission connects to the engine. To reach it, you may need to lift the car and potentially remove some components for better access.
for me there is no money it how much you love your car
about 10k
It is right behind the distributor. IT is HARD to get to.
what is the smog and vaccum diagram for the 87 Pontiac fiero 2.5L 4 cylinder what is the smog and vaccum diagram for the 87 Pontiac fiero 2.5L 4 cylinder