There are two parts to this. the Temp sensor is just under the air intake. one clip that has two wires on it. You will need a deep well socket. I think a 3/4 will do it. You might have to remove the air breather to see it as it's very deep under the air intake. Now there is also a "temp switch" it's about at the same height as the sensor on the motor but it's on the fire wall side. It uses the same wire harness so just follow that as it's the second thing in line to the sensor. It has only one wire going to it. I replaced the sensor and the gauge didn't do anything. Then I got the "switch" and it's all ok now. each part was 20 bucks at auto zone. Easy to fix.
The temperature sensor is located is located next to the thermostat in the engine block. It is on the driver side of the engine compartment.
Answer , location of temperature sensorI just changed the Temperature sensor on my Pontiac and it was located on the engine block right underneath the throttle control.
The temperature sensor to the computer is located on the thermostat housing. On the 4 cylinder it is on the right side of the engine block.
On front driver's side of engine block.
The 1994 Chevy 454 cubic inch big block engine temperature sensor is located on the front of the engine. The engine temperature sensor will be a few inches above the thermostat housing.
On a 2002 Ford Windstar, the temperature sensor for the gauge is located on the engine block, typically near the thermostat housing. It's usually found on the passenger side of the engine, close to where the upper radiator hose connects to the engine. The sensor is threaded into the block and can be identified by its electrical connector.
Answer , location of temperature sensorI just changed the Temperature sensor on my Pontiac and it was located on the engine block right underneath the throttle control.
Right above the oil filter , in the engine block.
In a 1993 Volvo 940, the block temperature sensor is typically located on the engine block, near the thermostat housing. It can be found on the driver's side of the engine, often near the cylinder head. This sensor monitors the engine's coolant temperature and sends the information to the gauge on the dashboard. If you're having trouble locating it, consult your vehicle's repair manual for a detailed diagram.
On a 1991 12-valve Cummins engine, the coolant temperature sensor is located on the engine block, near the thermostat housing. It is typically found on the driver's side of the engine, towards the rear, and is screwed into the block. This sensor monitors the engine's coolant temperature and sends the information to the engine control unit or gauge.
drivers side of engine block
coolant temperature sensor are located where the coolant runs in the block near the thermostat housing normally the connector are on top of the sensor and the sensor itself screws in with a deep socket. The temperature sensor is usaully located where the coolant runs OUT of the engine close to thermostat housing.