0
What else can I help you with?
Where is the throttle position sensor on a 2004 Chevy Astro van?
Attached to the side of the throttle body.
What is causing your 1995 astro van to idle very high?
try your tps sensor . means throttle position . may be giving a false reading. /
Where is the map sensor on a 2001 astro van 4.3?
Remove the dog house in the van and the M.A.P. sensor is located behind the throttle body on the top of the manifold on the passenger's side. It is a flat sensor.
Where is oxygen sensor located on 2004 astro van?
where is the oxygen sensor in a 2004 astro van
Where is crank sensor on 97 Chevy astro van 4.3?
The crank position sensor On your astro is located on front of the engine on timing cover, left side. Behind the crankshaft pulley. with a connector of 3 wires.
Where is the camshaft sensor located on 2004 Chevy Astro?
On a 2004 Chevy Astro, the camshaft sensor is located in the front of the engine. It is on the left side of the timing cover behind the camshaft sensor.
How can you change a camshaft position sensor on your Chevy astro van 1988?
Camshaft position is taken from the distributor, there is no separate sensor.
Where is egr valve located 95 astro van?
directly under throttle body
Where is the fuel regulator located on a 1993 Chevy astro ext van?
In the throttle body.
What is a Baro sensor and where is it located on 1993 Chevy Astro Van?
A
Sensors on a 91 astro van?
The 1991 Chevrolet Astro van may have various sensors such as the oxygen sensor, throttle position sensor, coolant temperature sensor, and mass airflow sensor. These sensors help monitor and adjust various engine functions to optimize performance and efficiency. If you are experiencing issues with your vehicle, it is recommended to have a professional diagnose and replace any faulty sensors.
2001 Chevy astro van will not stay running when accelated replaced fuel pump replace mass air flow sensor replaced throttle position sensor crank sensor when you start it it misfires for a little bit?
probably misaligned your crank sensor.. I'm dealing with the same problem, might need to replace with new and make sure to gap properly.
