how do you remove the tourque convetor botls to flex plate on a 2003 explorer
On a 2004 Ford Freestar : The fuel pump inertia switch is located in the cargo area behind the service panel cover on the passenger side of the vehicle
are you asking about a torque converter or exhaust converter
On a 2004 Ford Freestar : The fuel pump shut off switch ( inertia switch ) is located behind the access panel on the passenger side of the cargo area ( where the vehicle wheel jack is also stored )
No.
On a 2004 Chevrolet Silverado in regards to a relay for the torque converter. After very intense research I cannot find anything that says it has a relay. I have never heard of any vehicle having a torque converter relay.
we had a 2004 ford an the torque converter was bad and what it did was not shift down in geers it would go strait from drive down to first so we repleace the converter and now it works find.4.24.11For further explanation and more symptoms of how to tell if a torque converter is bad follow this link on Ehow.com: http://www.ehow.com/how_5197449_tell-torque-converter-bad.html
2007 Freestar torque is 111 lb. ft / 150nm. on the front axle wheel end nut, as per the 2007 Ford repair manual. I would think the 2004-2006 would be the same since it is basically the same car.
Ford Freestar was created in 2004.
On a 2004 Ford Freestar : 1-----2-----3 ( bank 1 ) 4-----5-----6 ( bank 2 ) front of vehicle > driver Bank 2 , sensor 1 would be close to the engine BEFORE the exhaust enters the catalytic converter
( 26 U.S. gallons ) for a 2004 Ford Freestar
One reason a 2004 Ford Freestar may stall out is because of a water damaged PCM. This is a common problem with the 2004 Ford Freestar.