I have a turn signal light that keeps flashing regardless of the control arm position. I think that the problem is in the turn signal control relay but I don't know where it is located. I did find the 3 prong relay located behind the center console but this is not the problem because I replaced it and have the same problem.
there is a compartment on the driver side when you open the driver door look by the hinge you will see a panel pull of relay is in there BEHIND A/C AND HEATER CONTROL PANEL, IN CENTER CONSOLE.
Turn signal headlamp switch
It is located on the side of the radio between the glove box and the radio if you turn the turn signal on you will feel it flash if you can't here it.
The speedometer signal is all electronic. There is no cable. The signal comes from speed sensors.The speedometer signal is all electronic. There is no cable. The signal comes from speed sensors.
The turn signal switch is on the left.The turn signal switch is on the left.
You have a failed bulb on the right side.
If the bulbs and fuse are good, replace the turn signal Flasher Relay.
The multifunction switch is the turn signal switch and whatever else is part of it.
There is a problem with the cam sensor or the wiring to it.
On a 2004 Chrysler Sebring, the turn signal relay is typically located in the fuse box, which is found under the dashboard on the driver's side. To access it, you may need to remove a cover to reveal the relays and fuses. The turn signal relay is usually labeled, so check the diagram on the fuse box cover for its exact location. If you're having trouble, consulting the owner's manual can also provide specific details.
Pull the end of the turn signal lever out about 1/8th inch. This only works with the lights on. Fog lamps will not work with headlights off.
The turn signal flasher is located in the light control moduel. That is located under the steering column. If you are having problems with turn signals, check the fuses before changing the light control moduel.