answersLogoWhite

0

Need to know which one you are looking for or, what does this vacuum control valve control.

User Avatar

Wiki User

10y ago

What else can I help you with?

Related Questions

Where is the Idle Air Control valve located on a 1998 Ford Explorer 6-Cylinder 4.0L SOHC?

On most models, the Idle Air Control (IAC) valve is located on the throttle body.


Where is the egr valve located on a 2000 Ford Explorer?

Where is the EGR valve located on a 2000 Ford Explorer


Where is the Swirl Control Solenoid Valve on a 2002 Nissan Pathfinder?

swirl valve is located cloce to throttle body has two vacuum tubes


Where is the loaction of the Vacuum switching valve 1999 Toyota Camry location?

The VSV is located on the intake manifold side of the emission control valve set.


How do you replace 2002 explorer pcv?

Just locate the PCV valve wich is located on the back side of the left valve cover on V6 and is located on the top of the left valve cover on a V8 just pull it out and disconnect the vacuum line and install new one.


Where is the vacuum control valve for the heater on a 1992 GMC suburban and how do I get to it?

The vacuum control valve for the heater on a 1992 GMC Suburban is typically located on the heater control assembly, often behind the dashboard. To access it, you'll need to remove the lower dash panel and possibly the center console, depending on the specific configuration. Once you have access to the heater control area, you can locate the vacuum lines connected to the valve. Be cautious with the electrical connections and vacuum lines during removal and installation.


Heater control valve there isn't vacuum and there isn't any heat?

My 2004 ford explorer there isn't any vacum from the present heater control valve and the blower has been replace and the themostat has been replace and there is a clicking behind the a/c unit


Where is the EGR valve located on a 1998 Ford Explorer?

On a 1998 Ford Explorer, the EGR valve is located on the intake manifold. It is behind the throttle body.


Is there a thermal vacuum valve on a 1999 Ford Ranger?

There is a heater control valve on the 1999 Ford Ranger. There is no thermal vacuum valve on this year of the vehicle.


Where is the location of the vacuum line for the heater control valve?

The vacuum line for the heater control valve is typically located near the engine compartment, connected to the intake manifold or the vacuum source of the engine. It runs to the heater control valve, which is usually situated on or near the firewall, allowing it to regulate coolant flow to the heater core based on the position of the temperature control inside the vehicle. Checking the vehicle's service manual can provide specific details for your make and model.


Where is the heater valve located on a 1998 ford explorer XLT and is it hard to put on?

THE VALVE IS UNDER THE HOOD, ON TOP OF THE ENGINE, IN FRONT OF THE PASSENGER WITH 4 5/8 HOSES AND ONE SMALL VACUUM LINE ATTACHED.


What does the heater valve do?

The heater control valve is used to shut off hot coolant from entering the core when the heater is in the off position. A heater control valve can be actuated by either a vacuum line or a cable from the vacuum heater control valve to the heater core. This hose should be warm; if not the heater control valve is stuck and needs to be replaced