It is inside the engine, driven by the timing belt.
A Chrysler pt cruiser does not have a reset.
It is in the fuel tank.
Book time is about 8 hours.
To replace the water pump on a 2002 Chrysler PT Cruiser, begin by disconnecting the negative battery terminal. Drain the coolant, then remove the drive belt and the timing belt cover to access the water pump. After removing the old pump, clean the mating surface, install the new pump with a new gasket, and reassemble everything by reversing the disassembly steps. Finally, refill the coolant and reconnect the battery.
Chrysler does not use inertia/reset switches.
== == == == == == == == == == == ==
It is part of the fuel pump module, inside the fuel tank.
The water pump is inside the passenger side of the engine driven by the timing belt.
It is inside the front of the engine, driven by the timing belt.
Inside the front of the engine, driven by the timing belt.
On the 2.4L it is inside the front of the engine, driven by the timing belt.
No.