the wiper motor is located under the black plastic cover at the bottom of the windshied on the outside of the car. remove wipers and about 6 plastic screws. the motor is held down by 3 bolts and is easy to remove. I puchased a rebuilt motor on e-bay for about $58.00.
How to replace wiper motor on a 1998 montero sport mitsubishi
Begin by removing the traveling arm retaining bolt from your 1998 Chevrolet Cavalier wiper motor. Remove the wiper motor retaining bolts. Remove the wiper motor wiring harness. Reverse the process to install your new wiper motor.
To replace a windshield wiper motor for a 1998 F150, first remove the bottom trim on the window. Then remove both wiper blade assemblies and all screws on the metal cowling. Remove the retaining clip from the wiper motor linkage and pull the controls rods off.
== ==
Dead spot in the motor replace the motor.
how do you replace a wiper control module in dodge 1998
To fix the windshield wipers on a 1998 Honda Passport, first check the wiper blades for wear and replace them if necessary. Inspect the wiper motor and the fuse; if the fuse is blown, replace it. If the motor isn't functioning, you may need to replace it or check the wiring for any issues. Finally, ensure the wiper arms are properly attached to the motor spline to avoid any operational problems.
replace the pulse board on wiper motor which is a black cover
take out the center bolt which is the linkage, then take out the 3 bolts that keep it in place and remove the motor, reverse to install.
The wiper motor on a 1998 Chevy Venture is up under the vents next to the windshield. It is bolted to the firewall.
The wiper motor for a 1998 Honda Civic is located on the firewall, underneath the vent cover, below the wipers.
To access the wiper motor on a 1998 Toyota Hiace, first, remove the plastic cover at the base of the windshield by unscrewing any screws or clips holding it in place. Next, disconnect the wiper arms by loosening the nuts and lifting them off the splines. Once the arms are removed, you can access the wiper motor, which is typically mounted under the cover. Unplug the electrical connector and unscrew the motor from its mounting to replace or service it.