You pour it into the plastic bottle on the left side of the engine compartment.
On the coolant bottle.On the coolant bottle.
I always fill mine where the transmission dip stick goes in.
To fill the radiator in your 2000 Dodge Dakota, first ensure the engine is cool and locate the radiator cap. Carefully remove the cap, using a rag if necessary to avoid burns, and then pour a 50/50 mixture of coolant and water into the radiator until it reaches the fill neck. After filling, replace the cap securely, and check the overflow reservoir to ensure it is also filled to the appropriate level. Start the engine and let it run for a few minutes, checking for leaks and ensuring the coolant circulates properly.
The fluid is added down the dipstick tube.
You add it down the dipstick tube.
You most likely have a blown head gasket.
The 2000 Dodge Intrepid with the 2.7L 6-cylinder came in two engines with code 'U' and 'EER.' Both engines specify a engine oil fill of 5-quarts, including the filter. 5 and 10W30 can be used in this engine. 0W30 can be used in arctic and severe winter conditions, in addition to all-season use.
First open up the radiator, then there's a drain plug on the bottom of the radiator. Fill with water and drain until clear. Fill it up and good to go.
5 quarts for filter service. 9 quarts dry fill approx.
Normally all you need to do is fill the fluid, start the car and turn wheel back and forth, check the fluid level, and repeat as needed until the fluid stays full.
drain and pull the old radiator out, slide the new one in and fill it up
2000 DODGE INTREPID 3.2L 6-cyl Engine Code JCAPACITIESEngine, with filter.......... 5.0 quartsCooling System, Initial Fill.......... 9.5 quartsAutomatic Transmission, 42LE Initial Fill.......... 4.6 quarts [1]Automatic Transmission, Total Fill.......... 10.0 quartsManual Transmission, .......... 4.4 pintsDifferential, Front.......... 1.5 pints [2] [1] With ENG at operating temperature, shift through all gears.Check fluid level in PARK and add fluid as needed.[2] 42LE transaxles built after 7-26-99 fill to 3/8" (9mm) below fill hole. TORQUESOil Drain Plug.....20 ft-lbs