You can usually borrow, rent or buy a GM OBD code scanner at most auto parts retailers. Since OBD2 has come out, the old version has been called "OBD1", but that's not what it was called when it was being used. The 1995 Eighty-Eight is a crossbreed. It uses the OBD-II connector but it is an OBD-I system. It appears that OBD-II code readers can handle this but I'm not positive.
hoe do you reset the check engine light in a 1995 land rover
Probably under $10.00
no
The engine light is on when the engine computer has detected a malfunction and set a trouble code.
Every sensor on the engine and transmission can cause the light to come on.
It's the " service engine soon " light to the left of the gas gauge instead of the " check engine " light , like it is on my 1995 Ford Explorer
Turn on the ignition and look at the instruments. You will see the Check Engine Light come on for a few seconds and then go off. If you see the light it is working.
The easiest way to reset the check engine light on a 1995 Acura Integra is to unhook the battery for a few minutes. If the light is still on after hooking it up again, there is probably still a problem that needs to be fixed with the engine.
www.troublecodes.net Good luck I have a 1995 jdauksz1@charter.net
To reset the check engine light on a 1995 Nissan Altima, first, disconnect the negative battery terminal and leave it disconnected for about 10-15 minutes. This will reset the vehicle's computer and clear the check engine light. Reconnect the battery terminal and start the engine to see if the light has turned off. If the light persists, there may be an underlying issue that needs to be addressed.
for the check engine light go to autozone and they will diagnose your engine for free as for the speedometer you will proobably have to replace the speed sensor
There are pages and pages of things that can cause a check engine light. You need to have it checked with a scantool. Then the code can be diagnosed and repaired.