as you are looking at the fan from the front of pickup it unscrews to the right and tightens to the left
switch under dash on clutch is bad
push in the clutch
If it will not even turn over. Locked up A/C compressor clutch. Disconnect the wire going to the compressor clutch. See it the engine will turn over.
To unscrew a nut, turn it counterclockwise.
Check the ground on your starter, i had a similar thing on my 94 ranger,( i turned the key with the clutch in and you just heard the fuel pump click) turned out my grounding wire broke) just needed to find a lug and reatach it and it works fine now
To unscrew bike pedals, turn them counterclockwise.
left kick panel by clutch right behind the turn signal relay
To remove the fan clutch from an Isuzu NPR, first, ensure the engine is cool and disconnect the battery. Then, remove the fan shroud and any necessary components blocking access to the fan clutch. Use a wrench to hold the water pump pulley in place while you turn the fan clutch counterclockwise to unscrew it. Once loose, carefully lift the fan and clutch assembly out of the engine bay.
look in a HAYNES auto manuel buy one or get from local library it should defenitly show you ^ Very informative. Thank you... The Haynes manual says that before installation of the new clutch to turn the disc counter clockwise to compress the springs. That's about all it says for any adjustments of the clutch. I just replaced mine (97 4wd ranger). If you find out more let us know.
To unscrew pedals from a bicycle, you need to turn them counterclockwise.
To remove the fan clutch from a 1992 Mercedes 190E 2.3-liter, first, ensure the engine is cool and disconnect the battery. Use a wrench to hold the water pump pulley in place while you turn the fan clutch counterclockwise to unscrew it from the water pump shaft. If it's stubborn, you may need to use a fan clutch holding tool. Once removed, inspect the clutch and replace it if necessary before reinstalling the new or existing fan clutch.
Turn it counterclockwise.