In the USA it was only called the Pacifica. In 2009 it was replaced by the new Dodge Journey (which is different vehicle).In the USA it was only called the Pacifica. In 2009 it was replaced by the new Dodge Journey (which is different vehicle).
A scan tool is required. You need the dealer or a locksmith.
Check ebay. A quick search there using "pacifica key" turns up a lot of results including complete new keys and key shells w/blade.
first you need to remove the old one. then you need to install the new one.
It sounds like your belts in your tires may be starting to separate. My mustang started to shake at highway speed. New tires cured it. My 05 Pacifica still rolls smooth. No problems so far
To replace the thermostat on a Chrysler Pacifica, first locate the thermostat housing just behind the alternator. Remove the two bolts holding this on, then remove the old thermostat. Replace with a new thermostat and thermostat gasket. The put the bolts back in and tighten down. Make sure to check the antifreeze levels after this project.
the alternator + replacing fees lies between $350-$400 if the alternator is remanufactured (not brand new). The cost may reach $600 if it is brand new
The 3.5L can and will bend valves. You may be looking at a new engine. Cost could be a couple thousand dollars.
To change the navigation disk in a 2004 Chrysler Pacifica, first, ensure the vehicle is turned on but the navigation system is off. Open the navigation system by pressing the "Eject" button on the unit, which should release the current disk. Remove the old disk and insert the new navigation disk, ensuring it is properly seated. Finally, close the navigation system and turn it back on to confirm the new disk is recognized.
To change the window motor in a 2007 Chrysler Pacifica, first, disconnect the vehicle's battery to ensure safety. Remove the door panel by unscrewing any screws and gently prying it off to access the window motor. Disconnect the wiring harness from the old motor, unbolt it, and replace it with the new motor, ensuring it's securely mounted. Finally, reattach the door panel and reconnect the battery to test the new motor.
To replace the rear wiper blade on a Chrysler Pacifica, you must first remove the old blade. You can remove it by pushing the small blade that holds the wiper in place up, and push the blade back. Once the blade is free from the hook remove it. Put the new blade in position so the hook is in position to go over the wiper attachment. Clip it into position and you are done.
To change the water pump on a 2007 Chrysler Pacifica 4.0, start by disconnecting the negative battery terminal and draining the coolant. Remove the serpentine belt, then detach the timing belt cover and the timing belt itself to access the water pump. Unbolt the old water pump, clean the mounting surface, and install the new pump with a new gasket. Finally, reassemble everything in reverse order, refill the coolant, and check for leaks.