0
Lack of lubrication would be the primary reason. Although another possibility might be that the engine is being over-revved at the time the OB computer senses the need to engage the AWD capability and the shock of the sudden engagement, while being over-revved, snaps the joints.
What else can I help you with?
How do you replace bearings on a Honda ATV?
See the related link below of how I changed my ATV bearings with picture......Dogbone
How do you find out if your Honda CR-V is 4wd or2wd?
Look under the car. If you see a differential with driveshafts going to each rear wheel, it's a 4WD or what Honda calls an All Wheel Drive.
How do you replace rear axle bearings Honda 300ex?
The rear axle bearings on a Honda 300ex are replaced by first removing the rear wheel. The bearing cap and retaining ring are then removed and the bearing is then pulled from its housing.
How do you change rear axel bearings Honda trx 300?
how do you change rear brakes on a 1990 Honda trx 300fwl
Is the wheel bearings on Honda rancher the same on front and back?
No, the wheel bearings on a Honda Rancher are typically not the same for the front and back. The front and rear wheel bearings are designed differently to accommodate the specific load and design requirements of each axle. It's essential to check the specifications for your particular model and year to ensure you obtain the correct bearings for replacement.
How long do Honda CRV rear wheel bearings typically last?
One year
What are the steps to replacing swingarm bearings on a 2003 Honda 350 rancher?
Should have bushings in it?
How do you change Honda rancher swingarm bearings?
To change the swingarm bearings on a Honda Rancher, start by lifting the ATV securely and removing the rear wheel and axle. Next, detach the swingarm from the frame by unbolting it from the pivot points. Remove the old bearings from the swingarm and clean the housing thoroughly. Finally, install the new bearings, reassemble the swingarm, and ensure all components are securely fastened before testing.
Do the front wheel bearings on a 1991 Honda Accord have to be pressed out?
yes they do. I have a 1991 Honda civic and I needed to press them in and I believe they have the same front end.
Does a 1991 Honda Civic have bearings?
Yes, tons of them. Might want to specify what bearing your asking about.
Does a 1982 Honda 185 atc have gear oil?
No, a 1982 Honda 185 does not have gear oil. The engine and transmission both use the same oil and draw from the same reservoir. The rear axle bearings are lubricated only with grease as are all other bearings.
What is the wheel bearing torque specs in ftlbs on a rear wheel bearing for a 1998 Honda Accord?
what is the torque on front wheel bearings for 1998 honda accord
