0
What else can I help you with?
What's color wire of MAP sensor going to the computer from Chevrolet Cavalier Z24 1988?
Purple
Does a 98 cavalier have a governor?
Yes 108 mph. VSS (Vehicle speed sensor) acts as the governor. You should not be going faster than 108 in a 1998 cavalier anyways though.
How do you fix a P0107 code on a 1998 Jeep Wrangler 4.0?
That is a MAP sensor code, check to see if the sensor is returning at least .5 volts, if not check for 5 volt reference voltage on the connector. If you have voltage going in, and none or less coming back out replace the sensor, if no reference voltage check the connectors, wiggle them and monitor the voltage. If the wiggle test checks out, draw a vacuum on the MAP sensor vacuum port. As you add vacuum the voltage should decrease. With no vacuum, the MAP sensor should read around 4.5 volts. If there is no change in MAP sensor reading on the scan tool, replace MAP sensor.
Where is the crank sensor located on a 1989 Z24 cavalier 5 speed?
back center of the block right above the oil pan it has 2 wires going to the one above it with one wire is the knock sensor
What is the difference between npn and pnp proximity sensors?
No worries. The important thing here is that this module is simply reading a voltage from the sensor with reference to the ground of that sensor. This means that this module is always going to be a sinking device, and will be always be sinking small amounts of current from that sensor. This means, that your sensor is going to be powered externally and we will simply be reading the output voltage from it. Here is a link to a knowledgebase article about sinking and sourcing current. I hope this helps to clarify.
Why is my 1992 auto Chevy Cavalier when i am accelerating to dog down it also acts like it is about to stall out and has dark grey to black smoke coming from the exhaust what is going on?
Oxygen sensor
How do you bypass oil level sensor on 2.2 cavalier engine?
Bypassing the oil level sensor on a 2.2 Cavalier engine typically involves disconnecting the sensor's electrical connector and then using a jumper wire to connect the terminals in the connector. This simulates a "normal" oil level reading. However, it's important to note that bypassing the sensor can lead to potential engine damage due to low oil levels going undetected, so it should only be done temporarily for troubleshooting purposes. Always ensure to monitor oil levels manually if the sensor is bypassed.
1994 Chevy Cavalier Z24- The speedometer is reading a faster speed than actually going about 40 mph faster Already changed the speed sensor Any ideas?
speedo cable?
Why No voltage going to the alternator?
Voltage flows from the alternator not to it. If it is outputting no voltage it is defective.
Your 1996 Cavalier spits and sputters if you sit too long at a red light sometimes even shuts off anyone got any ideas as to what in the heck is going on here?
change your O2 sensor
How do you know when water pump on cavalier is going out?
They will leak
With a 2003 Honda Accord is it necessary to replace the entire throttle when the throttle position sensor has been diagnosed as having low voltage and is going bad?
NO. Honda will sell the sensor, gasket and bolts for $150. Take them about 1/2 hr. labor to put it on.
